Operation control

The tab Operation control helps you to set service interval to control vehicle parameters telling that the next schedule is due, and also to set threshold values for absence of data and for disparity between mileage (values of km travelled) received from CAN and from GLONASS.

These settings can be applied to a group of objects (if you have selected the necessary root directory in the vehicle structure), or to separate objects in the vehicle structure.

Service interval

You need to input the value for the service interval (km). Having run this amount of km, a vehicle must undergo a scheduled maintenance.

This parameter is necessary to control parameters which inform that the next schedule is due.

Threshold values for system events

Threshold value of data absense period (h). You need to set the threshold value for the time interval during which data is not received from a GPS receiver.
Threshold value of disparity btw. CAN and GLONASS mileage (km). You need to set the acceptable value for the disparity between mileage values received from GPS receiver and from CAN-sensor. Before this, you need to configure the CAN-sensor for the monitored object.

After you set the threshold values, you need to export the vehicle fleet via Vehicle fleet administrator.

When an event occurs, the information about this event will be displayed in the window Important events, in the tab Events in the Telemetry Panel, and also in the generated user-defined "Events" report.

To set the display of an event marker on the map, see the section Settings - General.

"Ok" button

Using this button, you save the changes and close the Settings window.

"Apply" button

Using this button, you save the changes, but the Settings window stays active.

"Cancel" button

Using this button, you cancel all the changes and close the Settings window.

"Help" button

Using this button, you open the Instruction for this section.