To properly display this page you need a browser with JavaScript support.
There are cases when a sensor installed on a vehicle transmits not real parameter values but conventional parameter values to the server (for example, the sensor gets data in millivolt, and this sensor must show fuel level in litres). In such a case one needs to use a calibration chart to get real parameter values.
"Calibration" tab The Calibration tab allows to create a chart for calibration of vehicle sensors.
List of calibration charts This field includes the list of all calibration charts for a selected vehicle fleet.
Number of points in a calibration chart In this field the number of points for the creation of a calibration chart is indicated.
Table for calibration chart creation In this table the values for the points are indicated, for the creation of a calibration chart.
Search of calibration chart This is a tool for searching a calibration chart by name.
Commands for editing of lists of calibration charts These commands help to create/delete entries in the list of charts.
Name of calibration chart Here you can create and edit the name of a calibration chart.
Axis titles The names of parameters for axis are displayed here.
Calibration chart This is an area for creating a calibration chart using the input values.
Comment A window where you can add a comment for a selected chart.
"Ok" button Using this button, you save the changes and close the Settings window.
"Apply" button Using this button, you save the changes, but the Settings window stays active.
"Cancel" button Using this button, you cancel all the changes.
"Help" button Using this button, you open the Instruction for this section.
